-40%
Neptune Apex Trident, Source Tube Winder, Tidier, 3D Printed
Neptune Apex Trident, Source Tube Winder, Tidier, 3D Printed
Neptune Apex Trident, Source Tube Winder, Tidier, 3D Printed
Neptune Apex Trident, Source Tube Winder, Tidier, 3D Printed

Neptune Apex Trident, Source Tube Winder, Tidier, 3D Printed

$ 7.91

Availability: 53 in stock
  • Return shipping will be paid by: Buyer
  • All returns accepted: Returns Accepted
  • Item must be returned within: 30 Days
  • Condition: New
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Type: Controller
  • Brand: Reef Prints
  • Restocking Fee: No

    Description

    Hello Reefers,
    Neptune Trident's source water tube cannot be trimmed because of the calibration. So when your trident's placement is too close to the sump, then your source tube cannot be routed to hide it out of place and cannot keep the setup looking tidy. So I created this Source Water tube Winder to be attached to the back wall of the stand, loosely wind the tube around the C sections, then push the tube into the clips that just the correct diameter that will not pinch the tube to cause any extra restrictions so not affecting the calibration.
    The tube winder is again 3D printed out of PETG (reef safe) and it will come with two stainless steel screws for attaching to your stand.
    Hope you like this.
    Thank you for your interest.
    Happy Reefing.